A solid, low stand for your phone, small tablet or e-reader. The device leans back on two wide fins and stands on a ledge, upright or sideways, and the gap between the fins leaves room for the charging cable. The base is a thick, solid pad, so the stand stays put when you tap the screen.
Fits: phones up to 14 mm thick including the case; small tablets and e-readers up to 14 mm thick. Open sides, so any width. Works in portrait and landscape.
In the box: one stand in the finish and colour you choose. The phone or tablet, cable, rubber feet and washers are not included. Photos show the Textured finish in Matte Black, holding a small display. Want another colour from the chart in the last photo? Message us before ordering.
Care: wipe clean with a damp cloth. PLA softens above about 55 °C, so keep the stand out of hot cars, full sun on a window sill, and away from heaters.
Desk use. Designed to hold one phone, small tablet or e-reader up to 14 mm thick (including its case) on a flat, level desk. It is a free-standing stand, not a mount: don't use it in a car, on a moving surface, or to carry the device. Keep the charging cable slack so it can't pull the stand over, and unplug the charger if the cable or plug gets hot. PLA softens above about 55 °C, so keep it out of hot cars and full sun. Damage caused by overloading, heat, modification, or use the product isn't designed for isn't a fault in the product. This doesn't affect your rights under the Australian Consumer Law.
Colour & finish. This product is made of several printed parts, so slight colour or sheen differences can occur between parts printed from different filament batches. Fine layer lines are part of the 3D-printed finish. This doesn't affect strength or fit.
What material is the Phone & Tablet Stand for Desk printed in?
Printed in plant-based PLA — made from renewable plant sugars (corn & sugarcane), not petroleum — with a lower carbon footprint than traditional plastics. Every order is printed to order in Melbourne, so there's no mass-production waste and nothing sitting in a warehouse.
What finish should I expect?
It's 3D printed to order, so fine layer lines and small support marks are normal. Need a smoother finish? Email [email protected] before ordering and we'll tell you what we can do.
How long does shipping take?
Australia: $10 standard / $15 express, free standard shipping over $100 · New Zealand: $15 · United States: $20 · Other countries: $25. Every item is printed to order and ships in 3–5 business days from Melbourne. Finish: every piece is 3D printed to order, so fine layer lines and small support marks are normal. Need a smoother finish? Ask us before ordering. Faulty, not as described or our mistake? We'll fix it, reprint or refund, and cover the return. To report a problem, email [email protected] with your order number and photos; we may ask for the item back. Changed your mind? Standard (non-personalised) items can be returned unused within 30 days of delivery, with return shipping at your cost; personalised or custom-made items can't be returned for change of mind. This doesn't affect your rights under the Australian Consumer Law. Full terms: formada3d.com/legal-en#returns
Where is it made?
Designed and 3D printed to order in our Melbourne, Australia workshop.
What's your returns policy?
Faulty, not as described or our mistake: we fix it, reprint or refund, and cover the return. To report a problem, email [email protected] with your order number and photos; we may ask for the item back. Change of mind: standard (non-personalised) items can be returned unused within 30 days, with return shipping at your cost. This doesn't affect your rights under the Australian Consumer Law.
FORMADA
