Paint Rack Brush Holder
$12.99 AUD
printed to order in Melbourne
🚚 Shipping: AU $11 (express $15) · US $20 flat
1
🇦🇺 Melbourne made📦 ships in 3–5 days↩️ ACL returns🔒 Shopify checkout
🌱 Printed in plant-based PLA — made from renewable plant sugars (corn & sugarcane), not petroleum — with a lower carbon footprint than traditional plastics. Every order is printed to order in Melbourne, so there's no mass-production waste and nothing sitting in a warehouse.
ABOUT THIS PRODUCT
Paint Rack Brush Holder — Clip-On Cup for the Pin-Canal Rack System
Your brushes, right where you paint. This cup clips onto the hidden connector canal of any of our paint racks — no screws, no glue, no tools.
The mounting arm reaches over the rack's spine and drops a diamond pin into the hidden canal built into every rack in our range (60 Bottle, 44 Pot / Citadel, 35 Bottle and all Pin-Canal racks). The cup hangs at the rack's side — brushes tip-up, off your desk, always in reach. Lifts straight off whenever you want.
Why painters love it
- Tool-free clip-on — diamond pin drops into the rack's hidden canal, the arm carries the load
- Deep Ø32 cup — holds a full handful of brushes, files or sculpting tools, 64mm deep
- Funnel floor with drain — drips and dust fall through, bristles stay dry
- Repositionable — move it to either side of any rack in seconds
- Printed to order in Melbourne from premium PLA
In the box
1 × clip-on brush holder cup (fits every Formada3D Pin-Canal paint rack — racks sold separately)
Specs
- Cup: Ø38 outer / Ø32 inner · 64 mm deep · funnel floor with drain
- Overall: 64 × 38 × 76 mm · Pin: 6.5 mm diamond, fits the v8 rack canals
- Material: PLA+, matte finish · Made to order in 3–5 days
- Available in 15 colours — match your rack or contrast it
Formada3D — practical 3D printed gear, designed and made in Melbourne.
SHIPPING & RETURNS
Australia: $11 standard / $15 express · United States: $20 flat. Every item is printed to order and ships in 3–5 business days from Melbourne. Returns per Australian Consumer Law — if it arrives faulty or not as described, we make it right.
MATERIALS & SUSTAINABILITY
Printed in plant-based PLA — made from renewable plant sugars (corn & sugarcane), not petroleum — with a lower carbon footprint than traditional plastics. Every order is printed to order in Melbourne, so there's no mass-production waste and nothing sitting in a warehouse. Colours available in matte and standard PLA — see the swatch chart in the gallery.
